S-4GPT-DSFP: Fiber Mode Converter SFP to SFP Protocol Transparent Media Converter

This green LED is turned on when power is applied to the media converter. This LED is off when there is no power supplied.

A Blinking LED will indicate that a hardware error has been detected.

Smart Link Pass-Through when enabled ( Default ) ensures that the link state on a fiber connection is directly reflected through the media converter to the other connection. If link is lost on one of the connections, then the other link will be brought down by the media converter. This feature applies when both SFP slots are occupied.

If set in Standard Mode, the link is kept active. The unit will transmit a 25Mhz keep-alive signal to artificially keep the link up.

If the media converter module detects a loss of fiber, it will immediately notify the fiber link partner that an error condition exists.

Disabled ( Default ). The Media Converter will not monitor for fiber fault.

When enabled, identifies that the SFPs inserted are MSA complaint SFPs that have a multi-rate capability.

When disable ( Default ), no action is performed in this context.

This enables rate selection when using dual-rate capable SFPs. If the “Multi-Speed SFP” select switch is in the “Disabled” position, this switch is ignored.

High Speed - UP ( default )

Low Speed – DOWN

SFP line rates up to 4.25Gbps are supported. The SFPs occupying each slot in the media converter must be operating at the same speed.

SFP power level 1 and 2 are supported.