DH11020S là bộ cách ly tín hiệu thụ động 2 kênh 4-20mA của hãng Drago - Đức hiện đang được BKAII phân phối rộng rãi tại thị trường Việt Nam. Bộ cách ly tín hiệu DH11020S được thiết theo tiêu chuẩn công nghiệp, nhỏ gọn, hiện đang được sử dụng trong các bài toán M2M, IoT của các lĩnh vực: Điện lực, khí tượng thủy văn, giao thông minh, hệ thống kiểm soát an ninh,…
Tính năng của sản phẩm:
- Galvanic isolation across input and output
Protection against erroneous measurements due to parasitic voltages or ground loops
- No power supply required
Saving costs since wiring is reduced and line influences are omitted
- Extremely slim design, 1- and 2-channel versions
Only 3.1 mm DIN-rail per channel
- Protective Separation acc. to EN61140
Protects service personnel and downstream devices against impermissibly high voltage
- Maximum reliability
No maintenance costs
Thông số kỹ thuật sản phẩm
Input
Input Signal |
0(4) to 20 mA |
Operating current |
< 200 µA |
Voltage drop |
< 2.3 V |
Overload |
≤ 50 mA, 30 V |
Output
Output signal |
0(4) to 20 mA |
Load |
600 Ohm |
Cut-off frequency -3 dB |
100 Hz |
Response time T99 |
5 ms |
Residual ripple |
< 10 mVrms |
General Data
Transmission error |
< 0.1 % full scale |
Load error |
< 0.05 % of measured value / 100 Ohm load |
Temperature coefficient 1) |
< 100 ppm/K |
Test voltage |
3 kV AC, 50 Hz, 1 min. all circuits against one another |
Working voltage 2) (Basic Insulation) |
Up to 600 V AC/DC for overvoltage category II and pollution degree 2 acc. to EN 61010-1 |
Protection against electrical shock 2) |
Protective separation according to EN 61140 by reinforced insulation in accordance with EN 61010-1 up to 300 V AC/DC for overvoltage category II and pollution degree 2 between all circuits. |
Ambient temperature |
Operation Transport and storage |
–25 °C to +70 °C (-13 to +158 °F) –40 °C to +85 °C (-40 to +185 °F) |
EMC 3) |
EN 61326-1 |
Approvals |
UL (USA/Canada): UL 61010, Class I, Div. 2 ATEX / IECEx: Zone 2 (nA) |
Construction |
6.2 mm (0.244") housing, protection class: IP 20 mounting on 35 mm DIN rail acc. to EN 60715 |
Connection |
Captive plus-minus clamp screws Wire cross-section max. 2.5 mm² / AWG 14 Stripped length 6 to 8 mm / 0.28 in Screw terminal torque 0.8 Nm / 7 lbf in |
Weight |
Approx. 70 g |