Serial interface |
|
Interface 1 |
Ethernet interface, 10/100Base-T(X) in acc. with IEEE 802.3u |
|
Interface |
Ethernet |
|
Connection method |
RJ45 socket, shielded |
|
1 port 10/100Base-T(X), auto negotiation |
|
Transmission length |
< 100 m (shielded twisted pair) |
|
Protocols supported |
Protocol-transparent for TCP/IP, IPv4, and IPv6 |
|
Serial transmission speed |
10/100 Mbps, auto negotiation |
|
Interface 2 |
SHDSL interface according to ITU-T G.991.2.bis |
|
No. of channels |
2 (2-wire operation) |
|
Connection method |
2 x 2-pos. COMBICON plug-in screw terminal blocks |
|
Transmission length |
< 20 km (Depending on data rate and cable cross section) |
|
Conductor cross section solid min. |
0.2 mm² |
|
Conductor cross section solid max. |
2.5 mm² |
|
Conductor cross section flexible min. |
0.2 mm² |
|
Conductor cross section flexible max. |
2.5 mm² |
|
Conductor cross section AWG min. |
24 |
|
Conductor cross section AWG max. |
14 |
|
Serial transmission speed |
4-wire operation: 64 kbps ... 30 Mbps |
|
2-wire operation: 32 kbps ... 15.3 Mbps |
|
Interface 3 |
USB 2.0 |
|
Connection method |
Mini-USB type B, 5-pos. |
|
Transmission length |
< 5 m (only for configuration and diagnostics) |
|
Digital outputs |
|
Output name |
Digital output |
|
Number of outputs |
2 |
|
Voltage output signal |
depending on the operating voltage |
|
Current output signal |
≤ 150 mA (Short-circuit-proof) |
|
Connection method |
2 x 2-pos. COMBICON plug-in screw terminal blocks |
|
Behavior of the outputs |
Deactivated for device supply via DIN rail connector |
|
Function |
|
Management |
Plug and Play, diagnostics via PSI-CONF software or web-based management (only with managed Ethernet extenders) |
|
Status and diagnostic indicators |
LEDs: US (supply voltage), ACT/LINK (Ethernet data traffic), ERR (errors) |
|
2x LINK / 2x STAT (DSL data traffic port A and port B), DIAG (diagnostic messages) |
|
Ambient Conditions |
|
Ambient temperature (operation) |
-20 °C ... 60 °C (Freestanding (40 mm spacing to the right and left), no supply of other modules via the device) |
|
|
|
|
Ambient temperature (storage/transport) |
-40 °C ... 85 °C |
|
Permissible humidity (operation) |
10 % ... 95 % (non-condensing) |
|
Altitude |
5000 m (For restrictions see manufacturer's declaration) |
|
Degree of protection |
IP20 |
|
General |
|
Electrical isolation |
VCC // Ethernet // DSL (A) // DSL (B) // FE |
|
Test voltage data interface/power supply |
1.5 kVrms (50 Hz, 1 min.) |
|
Standards/regulations |
EN 50121-4 |
|
Electromagnetic compatibility |
Conformance with EMC Directive 2014/30/EU |
|
Net weight |
258.7 g |
|
Housing material |
PA 6.6-FR |
|
Color |
gray |
|
MTTF |
711 Years (SN 29500 standard, temperature 25°C, operating cycle 21 % (5 days a week, 8 hours a day)) |
|
308 Years (SN 29500 standard, temperature 40 °C, operating cycle 34.25 % (5 days a week, 12 hours a day)) |
|
125 Years (SN 29500 standard, temperature 40°C, operating cycle 100 % (7 days a week, 24 hours a day)) |
|
Conformance |
CE-compliant |
|
Power supply |
|
Nominal supply voltage |
24 V DC ±5 % (as an alternative or redundant, via backplane bus contact and system current supply) |
|
5 V DC (configuration only, via mini-USB type B) |
|
Supply voltage range |
18 V DC ... 30 V DC |
|
Typical current consumption |
< 180 mA (24 V DC) |
|
Connection method |
COMBICON plug-in screw terminal block |
|
Standards and Regulations |
|
Electromagnetic compatibility |
Conformance with EMC Directive 2014/30/EU |
|
Vibration resistance |
In acc. with EN 60068-2-6/IEC 60068-2-6 Result: 5g, 10...150 Hz, 2.5 h, in XYZ direction |
|
Shock |
In acc. with EN 60068-2-27/IEC 60068-2-27 Result: 15g |
|
EMC Immunity |
EN 61000-4-2: Contact discharge ± 6 kV, Indirect discharge ± 6 kV EN 61000-4-3: Frequency range 80 MHz ... 3 GHz EN 61000-4-4: Criterion B EN 61000-4-5: Signal ± 1 kV (asymmetrical, shielded Ethernet cable) EN 55011 EN 61000-4-6: Frequency range 0.15 MHz ... 80 MHz EN 50121-4 |
|