ioLogik R1200 Series: RS-485 remote I/O

Digital Inputs

I/O Mode

Wet Contact (DI to COM)

Points per COM

Connector

Sensor Type

DI or event counter

On: 10 to 30 VDC

Off: 0 to 3 VDC

ioLogik R1210/R1212 Series: 8 channels

ioLogik R1214 Series: 6 channels

Screw-fastened Euroblock terminal

Dry contact
Wet Contact (NPN or PNP)

Input/Output Interface

Analog Input Channels

Configurable DIO Channels (by software)

Isolation

Digital Input Channels

ioLogik R1240 Series: 8

ioLogik R1212 Series: 8

3k VDC or 2k Vrms

ioLogik R1210 Series: 16
ioLogik R1212 Series: 8
ioLogik R1214 Series: 6

Digital Outputs

Connector

Current Rating

I/O Type

I/O Mode

Over-Current Protection

Over-Temperature Shutdown

Over-Voltage Protection

Screw-fastened Euroblock terminal

200 mA per channel

Sink

DO or pulse output

0.65 A per channel @ 25°C

175°C (min.)

45 VDC (typical)

Input Voltage

Power Consumption

12 to 48 VDC

ioLogik R1210 Series: 154 mA @ 24 VDC
ioLogik R1212 Series: 187 mA @ 24 VDC
ioLogik R1214 Series: 207 mA @ 24 VDC
ioLogik R1240 Series: 216 mA @ 24 VDC
ioLogik R1241 Series: 343 mA @ 24 VDC

Analog Inputs

Input Impedance

Input Range

Sampling Rate

Accuracy

I/O Mode

10 mega-ohms (min.)

0 to 10 VDC
0 to 20 mA
4 to 20 mA
4 to 20 mA (with burn-out detection)

All channels: 12 samples/sec
Per channel: 1.5 samples/sec

ioLogik R1240:
±0.1% FSR @ 25°C
±0.3% FSR @ -10 to 60°C

ioLogik R1240-T:
±0.1% FSR @ 25°C
±0.3% FSR @ -10 to 60°C
±0.5% FSR @ -40 to 75°C

Voltage/Current

Baudrate

Connector

Pull High/Low Resistor for RS-485

Serial Standards

Data Bits

Stop Bits

1200 bps to 921.6 kbps

Terminal block

1 kilo-ohm, 150 kilo-ohms

RS-485

8

1, 2

Storage Temperature (package included)

Ambient Relative Humidity

-40 to 85°C (-40 to 185°F)

5 to 95% (non-condensing)