ESP32-DevKitC

The ESP32-DevKitC contains the entire basic support circuitry for the ESP-WROOM-32, including the USB-UART bridge, reset- and boot-mode buttons, LDO regulator and a micro-USB connector. Every important GPIO is available to the developer

The ESP32-DevKitC pinout is optimized to enable prototyping on a breadboard. The on-board LDO output is led out for powering up additional off-board electronics. Peripheral outputs are grouped together for hassle-free prototyping

Introduction:
ESP32 is already integrated antenna and RF balun, power amplifier, low-noise amplifiers, filters,
and power management module. The entire solution takes up the least amount of printed circuit board area.
This board is used with 2.4 GHz dual-mode Wi-Fi and Bluetooth chips by TSMC 40nm low power technology,
power and RF properties best, which is safe, reliable, and scalable to a variety of applications.

Features:

• High performance-price ratio
• Small volume, easily embeded to other products
• Strong function with support LWIP protocol, Freertos
• Supporting three modes: AP, STA, and AP+STA
• Supporting Lua program, easily to develop
• USB – 1x micro USB port for power and programming
• Misc – BOOT and EN buttons, red (power) and blue (GPIO2) LEDs
• Power Supply – 5V via USB or Vin pin
• Dimensions – 51.4 x 28.3 mm

"BKAII -Thiết bị truyền thông TỐT nhất với giá CẠNH TRANH nhất!"